Featured Products

Fiberglass Strength Member
Gotex FG

Fiberglass Strength Member
Gotex FGU

Fiberglass Strength Member
Gotex FG SL

Fiberglass Strength Member
Gotex FGU SL

Fiberglass Strength Member
Gotex FG L

Fiberglass Strength Member
Gotex FGU L

Fiberglass Strength Member
Gotex FG PU

Fiberglass Strength Member
Gotex FGU PU

Fiberglass Str. Memb. PE Adhesion
Gotex FG Ultrabond PE

Fiberglass Strength Member Anti-wick
Gotex FG AW

Aramid Fiber Strength Member
Protos HM

Aramid Fiber Strength Member WB
Protos HM UBC

Aramid Fiber
Protos SM
(Strength Member / Ripcord / Binder)

Aramid Fiber WB
Protos SM UBC
(Strength Member / Ripcord / Binder)

Aramid Fiber Ripcord
Protos Ripcord / UBC

Strength Member
StremX HM / UHM

Strength Member
Gotex StremX HY

Polyester Binder
Gral Binder LS

Polyester Binder
Gral Binder SLS

Polyester Binder WB
Dabond UBC

Polyester Ripcord
Gral Ripcord

Swellable Yarn
Ultrabloc SY

Swellable Yarn
Ultrabloc F

Gotex FRP

Gotex ARP


XTRU N

Synergex

Lattice and Lattice Lite

Lattice Lite Eco

Fiberglass Woven Tape
Gotex FG WT

Aramid Woven Tape
Protos WT

Aramid Extruded Tape
Gotex XTRU PE A

Aramid Extruded Tape
Gotex XTRU PP A

Insulation Tape
Mica Tape
(Phlogopite, Muscovite, Synthetic,
PE and PP Coatings)

None Woven Waterblocking
Polyester Tape
None Conductive / Semi Conductive
Applications
Solutions


Information Hub




FAQs
- Check your presser foot has enough pressure applied to the fabric to give positive feed.
- Check and clear your feed dogs of any lint that may have built up.
- Check and adjust the height of the feed dogs.
- Check your stitch length regulator as it may be set to zero stitch length.
- Check the thread tension as it may be loose and the thread may be clogging under the presser foot.
- Check your needle plate to ensure it is fixed securely.
Coats does not recommend of adding any additional lubricant/silicone on thread. Thread colour may change, it can create large variation of frictions, causing oil stain. Also, atomised silicone may become a health issue if inhaled by operators / machinists.
The dye uptake depends on many parameters such as cotton type, quality, finish etc. and any difference in these parameters between the fabric and thread will result in shade difference.
To improve seam elongation it is possible to increase the stitch rating per cm or inch, increase the bite, reduce the needle / looper tensions on affected seams or change thread types used.