Coats Colour Express
Registered users can place Sample Orders. Contact the local Coats office for registration.
Registered users can place Bulk Orders. Contact the local Coats office for registration.
Workwear and uniforms - Work Coats
We offer a range of sewing threads for workwear coats which can be subjected to much higher levels of wear and cleaning than more conventional garments, lasting its entire lifetime.
Gramax Tex 18 is sometimes used on the overlock loopers to reduce the overall thread cost in the garments.
Alternative thread types may be used depending on required final quality. The thread size will determine the choice of needle size.
For more information, check out our recommendations below.
We can tailor the product application guide to show you the exact information you require, please select the necessary options from the filter below. Below are recommended stitch types for this end use item.
Where two Tex sizes of thread have been suggested the choice will be determined by the fabric weight, the construction of the load bearing seams and the stitch definition required (topstitching).
The sewing thread recommendations laid out above are intended as a guide to aid the construction of garments with good quality seams. As garments of the same generic type differ in terms of fabric substrate and construction, and both making up methods and post make up processing can greatly vary, these recommendations should be viewed as a good starting point for thread selection.
Garment specific recommendations for thread and needle selection as well as accurate thread consumption figures and on-site technical support can be obtained by contacting your local Coats' office.
These recommendations and consumption figures are intended as a guide only and are given in good faith but without warranty or liability on the company or its employees.